Auvik comes pre-configured with more than 50 alerts. Any of these alerts can be edited, though there are some for which you can’t edit the trigger and clear conditions. That’s to prevent the creation of logic errors or endless loops that can cause the alerts to misfire.
You can also add your own alerts to customize Auvik to your environment.
Whether creating your own alerts, or modifying preconfigured alerts, you can include a variable in the alert description.The variable provides more detail about the device or interface that triggered the alert.
You can filter the alerts list to show only certain alerts. For more information on filtering, see How to filter data in Auvik.
For details on a specific pre-configured alert, please refer to the appropriate Alert article listed below.
Emergency alerts
- VMware Hypervisor CPU module failed
- VMware Hypervisor RAM module failed
- VMware Hypervisor hard drive failed
- VMware Hypervisor power supply failed
Critical alerts
- Auvik collector disconnected
- Distributed file system replication
- High broadcast traffic
- VMware Hypervisor CPU module degraded
- VMware Hypervisor RAM module degraded
- VMware Hypervisor hard drive degraded
- VMware Hypervisor power supply degraded
- Internet connection is lost
- Network element offline
- Spanning tree change
- Stack switch member status change
- Stack switch port status change
- UPS - Low battery change
- UPS - Possible power outage
- VPN remote gateway is lost
Warning alerts
- Number of SSL VPN sessions has reached the maximum alert
- Auvik collector discovery
- Configuration polling
- Default route change
- Firmware change on network element
- High CPU utilization
- High interface utilization
- High memory utilization
- High storage utilization
- Infrastructure device offline
- Interface status mismatch
- Packet discard(s)
- Packet error(s)
- Printer - Input tray missing
- Printer - Low ink level
- Printer - Low paper
- Printer - Out of ink
- Printer - Out of paper
- Printer - Output tray missing
- Printer - Paper jammed
- Printer - Offline
- Recent VMware snapshot not taken
- UPS - Battery needs to be replaced
- VMware snapshot limit exceeded
- VMware snapshot repository size exceeded
Informational alerts
- High number of SSL VPN sessions in use alert
- Low number of available SSL VPN sessions alert
- High percentage of SSL VPN sessions in use alert
- Configuration backup
- Configuration restored
- Different subnets
- Different VLAN number
- Different VLAN types
- Interface duplex mismatch
- No IP address
- Non-routable IP
- Route not used
- Trunk port not shared
- VLAN with no interfaces